Our Omniscans are the ideal solution for flange face corrosion inspections utilizing phased array techniques. Depending on the inspection requirements, Oceanscan can provide either an Omniscan 1664 for simple image capture reporting or an Omniscan 16128 for full encoded data capture analysis. Oceanscan has the technology.

Three tried and tested probe positions are on the flange tapper, between the bolt holes and on the outer rim, illustrated below. The shear wave inspection is usually carried out from 35 to 70 degree when fitted with a 55 degree wedge; data is displayed in S-Scan.

TURN-KEY-KITS;

Omniscan M 1664 (image freeze) combined with the 5L16 A10/A11 & N55S wedge.

Omniscan 16128 (full date capture) combined with the 5L16 A10/A11 & N55S. 4L16DGS integrated probe also available.

NOTE: Other methods available and as with all inspections, care must be taken with probe selection, setup and calibration.

OCEANSCAN LIMITED
DENMORE ROAD, BRIDGE OF DON, ABERDEEN, SCOTLAND U.K, AB23 8JW
TEL; +44(0)1224 707000, FAX: +44(0)1224 707001

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Website: www.oceanscan.co.uk
Accredited to BS EN ISO 9001:2000

{jcomments on}