Noise Control

European legislation has reduced allowable noise levels by 5 dB

In practice noise date are not always consistent. Noise at machines can stem from unknown sources. It is important to know what noise levels can be found in the system and what causes them. PRUFTECHNIK Condition Monitoring performs acceptance measurements of noise emissions and compares the results with the latest standards. If necessary, suitable measures for noise reduction are identified and recommended. Measurements are made with the data analyzer VIBXPERT and evaluated with DBSpectra and the software OMNITREND. Dominant noise sources can be identified using third octave or narrow band spectra.

“Achievable noise reductions, e.g. in gear drives, can be up to 5 dB: through measures on housings, up to 7 dB: through measures on rotors, toothing and housings and up to 10 dB: through secondary noise shields or enclosures” says Dr. Edwin Becker, Manager Service and Diagnostic Center.


Contact for further information: This email address is being protected from spambots. You need JavaScript enabled to view it. Geraeuschpegel NoiseLevels 1 (603 kB)
Pin It

This website is owned and operated by: MSL Media Limited

msl logo

Co. Number: 05359182

© 2022 MSL Media Ltd. All rights reserved. E&OE

ems logo mobile